Table of Contents
Advertisement
System Messages
Message
Cause
352
You are attempting to select a screen that does not exist
or has been disabled by the function Hide.
353
The minimum value is greater than the maximum value
for variable scales.
354
You are attempting to enter a value in an input field when
the current password level is insufficient for input.
355
Entry of this variable has not been configured for the
current PLC mode.
356
A print function has been initiated on the OP. When at-
tempting to print it has been ascertained that the printer is
offline.
357
You are attempting to enter a setpoint that contains an
illegal character.
358
The OP is currently executing a function which does not
permit use of the OP while it is in progress.
365
Incorrect index.
370
Hard copy print-out has been cancelled manually.
371
Print function disabled at present.
372
The function started has been cancelled.
383
For information: transfer of data records completed.
384
Data record required is not on data medium.
385
Information message: transfer of data records from OP to
data medium or vice versa has been initiated.
386
Information message: transfer of data records from OP to
PLC or vice versa has been initiated.
387
Data record not found.
388
Activating selected function.
389
De-activating selected function.
391
No Help text configured.
C-6
Remedy:
Minimum and maximum values are being
confused by OP. To prevent this, enter cor-
rect minimum and maximum values.
Log on with a higher password level.
Switch the printer online.
Check the connection between the OP and
the printer.
Has the printer been connected to the cor-
rect interface?
Enter the value correctly.
Wait until the function has been completed.
This message may appear in the case of
recipe functions, for example.
A multiplex index is outside the defined
range.
Check the data record selection parameters
(recipe, data record name, data medium) or
use the Select function to select the data
record.
One possible reason is that operation is no
longer possible:
The PLC has not reset the corresponding
The PLC has not reset the corresponding
control and acknowledgment bit, which
deactivates the recipe mailbox lock, in the
interface area.
There is no data record relating to the se-
lected recipe on the data medium.
Check configuration.
TP27, TP37 Equipment Manual
Release 01/00
Advertisement
Table of Contents
