GreenWorks SN-200-T Owner's Manual page 15

ASSEMBLY INSTRUCTIONS
INSTALLING THE CHUTE CONTROL ROD (See Figure 4)
• Position the discharge chute (1) so that it faces forward.
NOTE: Align the arrow (2) on the discharge chute with the arrow on the housing. (Fig. 4.1)
• Align the holes (3) on the upper chute control rod (4) with the holes on the lower chute control
rod (5). Insert the hitch pin (6). Insert the end of the chute control rod (7) through the keyed
hole (8) in the bracket that is attached to the top of the middle handle. (Fig.4.2)
(7)
(5)
13
(1)
(2)
Fig. 4.1
(6)
(3)
Fig. 4.2
(4)