3c
Connecting enclosures
Connect disk enclosures according to the following rules:
SAS expansion cables must be naturally bent, and a minimum of 97 mm (3.82 inches) clearance must be
reserved in front of each enclosure for winding cables.
The number of disk enclosures connected to the expansion ports on the controller enclosure cannot exceed
the upper limit.
Connect the expansion interface module of controller A to expansion module A of a disk enclosure, and
connect the expansion interface module of controller B to expansion module B of a disk enclosure.
When connecting cables between two disk enclosures, connect the P0 port on one disk enclosure to the P1
port on the other disk enclosure. When connecting a disk enclosure to a controller enclosure, connect the
onboard expansion port or the port on the expansion interface module of the controller enclosure to the P0
port on the disk enclosure.
For a storage system with two or more disk enclosures, set up multiple loops and evenly allocate those disk
enclosures to the loops.
All disk enclosures in the same loop are connected by two independent links. To be more specific, the
forward and backward connection mode is used for optimal network reliability.
Scenario 1 Connecting disk enclosures
2 U controller enclosure connected to two disk enclosures
Controller enclosure
Disk
enclosure 2
Expansion
module B
Expansion
module A
Disk
Enclosure 1
Controller A
Controller B
15