Coin-Cell Battery; Removing The Coin-Cell Battery - Dell P116G Service Manual

Steps
1. Place the display assembly on a clean and flat surface.
2. Align and place the palm-rest and keyboard assembly on the display assembly.
3. Using the alignment posts, close the left and the right display hinges.
4. Replace the four screws (M2.5x5) that secure the left and the right display hinges to the palm-rest and keyboard assembly.
5. Connect the display cable to the system board and adhere the tape that secures the display-cable connector.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in

Coin-cell battery

Removing the coin-cell battery

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
4. Remove the wireless card.
5. Remove the solid-state
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
Steps
1. Disconnect the speaker cable from the system board.
2. Peel off the tape that secures the speaker cable to the system board.
40 Removing and installing components
After working inside your
Before working inside your
drive.
computer.
computer.