Installation - American Standard Cadet 5267A60CL Owner's Manual

INSTALLATION

1
Non-skid
rubberized pad
Mounting
Tray
Open the hardware pack and
remove the mounting tray
for the hinge. If the non-skid
rubberized pad is not
attached to the bottom of
the tray, insert the post into
the mounting holes.
4
Insert bolts through the
mounting holes in the hinges
and the two on the back of
toilet bowl, make sure the
bolt is in the hinge as
illustrated in lower left.
7
Use a Phillips head
screwdriver to tighten
bolts. Hold the nut while
you use the screwdriver.
9
Fig. 1
To better clean the toilet, raise the hinge covers and slide toilet seat forward to remove from toilet
(Fig. 1). To clean the seat, wipe with warm soapy water with an antimicrobial ingredient like those
found in a dishwashing detergent. Common bathroom cleaners that are non-caustic and non-abra-
sive may be used (Fig. 2). To replace the seat, slide the seat back on to the mounting pad (Fig. 3)
and close covers (Fig. 4).
760406-100 Rev. 4 (7/23)
2
Place the mounting tray into
the groove of the hinge.
NOTE: Mounting tray can
only be inserted one way
with rubberized pad facing
toilet. NOTE: Do not close
the cover of the hinge.
5
Put the cone washers on to
the bolts. Push the Quick
Install Nut up the bolts.
Fig. 3
Fig. 2
3
Place seat on bowl while
carefully aligning seat with
bowl.
6
Cone
Washer
Quik-Lok
Nut
Press on the head of the
bolt while pushing the Quick
Install Nut up the bolt. Screw
the nut to tighten it on the
bolt.
8
Close cover of mounting
hinge.
NOTE: Do not use
Fig. 4
abrasive pads, acid
based or petroleum
based cleaners.