Starck free-standing tub filler trim 10456XX1 Technical Specification Maximum water pressure 145 psi Recommended water pressure 14.5 - 72 psi Maximum hot water temp. Recommended hot water temp 120 - 140 Max. flow rate @ 45 psi 5.8 gpm This unit is not anti-scald. If anti-scald capability is desired, is or required by local plumbing codes, install re- mote pressure balancing valve 13418181 to the hot and cold supplies before they go into the 10452181 rough.
Installation Instructions • Turn off the water at the main. • Cut the plaster shield so that it extends 3/8" above the surface of the finished floor. • Use an 8 mm allen wrench (not included) to remove the three screws from the flush housing.
Page 4
non-staining bathroom sealant suitable for the floor material. Gently guide the escutcheon to the floor. Insert a black rubber gasket in one end of the hose, and screw it to the hose outlet. Insert a second black rubber washer in the other end of the hose and screw it to the handshower.
Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty.
Page 7
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: Conditions, malfunctions or damage not resulting from defects in material or workmanship. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions.