Canon imagePRESS V900 Manual page 134

Canon
Characteristics
Adjust Gloss/Fine Black
Change Fold/Stitch Position
Adjust Saddle Stitch Fold
Position
Adjust Saddle Fold Position
Adjust Hole Punch Position
Correct Tail End Toner
Application
Adjust Fixing Pressure
Auto Adjust L/R Edge
Alignment
Adjust Primary Transfer
Voltage
Adjust Fan for Paper
Conveyance
Detect Multiple Sheet Feed
Paper Fiber Direction Settings
Adj. Lead Edge Sec. Transfer
Volt.
Adj. Paper Conveyance
Use as Template Paper
Adjust Temp. to Prevent
Wrinkles
Embossing Depth
Reduce Speed Loss for Image
Quality Priority
Revision 2 imagePRESS V900/V800/V700 Customer Expectations Document
imagePRESS V900/V800/V700 Customer Expectations Document
Adjust the glossiness and fine black of the custom paper
type
Change the saddle stitch position of the registered custom
paper type (when using Booklet Finisher-AG1). This setting
overrides any productivity modes selected.
Change the fold position of the registered custom paper type
(when using Booklet Finisher-AG1)
Change the saddle fold position of the registered custom
paper type (when using Booklet Finisher-AG1)
Change the hole punch position of the registered custom
paper type
When curled paper or paper susceptible to curling is used for
two-sided copying/printing, toner may not be adequately
applied or the color may become faint on the tail end (from
the feeding direction) of the paper
Adjust the fixing Pressure when using long originals, paper
which has absorbed moisture, or thin paper, to improve
paper creasing and curled edges
Prevent the printed image from being misaligned vertically as
seen from the paper feeding direction
Change the primary transfer voltage to fix variation in black
images.
If a paper jam often occurs or the output paper is creased
and it has a wave like appearance, you may be able to solve
the problem by increasing the fan level for paper conveyance
before fixation
Enable multiple sheet feed detection
Set the fiber direction to reduce jams
Change the leading edge secondary transfer voltage (the
voltage when transferring the toner image to the paper) of
the registered custom paper
If image problems or paper jams occur while printing, adjust
the paper feeding speed in the area before toner fixation
Set this mode to <On> to use preprinted paper (paper which
has logos already printed on it), such as a letterhead
Change the wrinkle correction level in the registered user
settings if wrinkles appear or the paper seems thin and worn
Select <Deep> when printing on textured paper that has
significant unevenness
Adjust the print speed when you select <Image Quality
Priority> in <Switch Fixing Temperature Adjustment Mode>
Parameters
Page 134