Connecting The Power Cord - Sharp PG-D4010X Operation Manual

When connecting to the LAN terminal using a LAN cable
Note
• When connecting to a hub, use a straight-through Category 5 (CAT.5) type cable (commercially
available).
• When connecting to a computer, use a cross-over Category 5 (CAT.5) type cable (commercially
available).

Connecting the Power Cord

Plug the supplied power cord into the
AC socket on the rear of the projector.
Then plug into AC outlet.
TX/RX LED (yellow)
Illuminates when transmitting/receiving data.
LINK LED (green)
Illuminates when linked.
* To ensure safety, do not connect the LAN terminal
with any cables that may cause excessive voltage
such as a telephone line.
To LAN terminal
LAN cable (Category 5 type,
commercially available)
Hub
or
Computer
AC socket AC socket
Power cord Power cord
(supplied) (supplied)
To AC outlet To AC outlet
25