Basic Operations; Connecting The Power Cord; Turning On The Main Power; Turning On The Power - Sharp PG-D120U Operation Manual

Basic Operations

a
b
c
or
d
e
On-screen Display
f.1
R G B 1 A D J .
R G B 1 I N P U T A D J .
I M A G E A D J .
A U D I O
S Y S T E M S E T U P
L A N G U A G E
: S E L . : N E X T
ENTER
MENU : E N D
E-11
When the main power is
on, the POWER indicator
lights up red.
When the power is on,
the LAMP REPLACE-
ON
MENT indicator flashes
to show the operating
condition of the lamp.
Green: Lamp is ready.
Flashing green: Warming
up.
Red: Change the lamp.
Focus knob
Zoom knob
f.2
L A N G U A G E
E N G L I S H
D E U T S C H
E S P A Ñ O L
g
N E D E R L A N D S
F R A N Ç A I S
I T A L I A N O
S V E N S K A
: S E L . : E N T E R
ENTER
MENU : E N D
a. Connecting the Power Cord
Plug the supplied power cord into the AC
socket on the back of the projector.
b. Turning on the Main Power
Press the MAIN POWER switch on the back of
the projector. The POWER indicator lights up
red and the projector enters standby mode.
• When the main power is not on, the remote control cannot
be used to operate the projector.
c. Turning on the Power
Press POWER ON on the projector or the
remote control.
• The flashing green LAMP REPLACEMENT indicator
shows that the lamp is warming up. Wait until the indica-
tor stops flashing before operating the projector.
• If the power is turned off and then immediately turned on
again, it may take a short while before the lamp turns on.
(During this period, the LAMP REPLACEMENT indicator
flashes.)
• After the projector is unpacked and turned on for the first
time, a slight odor may be emitted from the exhaust vent.
This odor will soon disappear with use.
d. Adjusting the Focus
Slide the focus knob until the image on the
screen becomes clear.
e. Adjusting the Zoom
Slide the zoom knob. The image can be ad-
justed to the desired size within the zoom
range.
f. Selecting the On-screen Display
Language
(See page 14 for details on using the
menu screens.)
The On-screen Display is set to "ENGLISH" at
the factory. The language for the On-screen
Display can be set to English, German,
Spanish, Dutch, French, Italian, Swedish or
Japanese.
1. Press MENU to display the menu screen. Press
ADJUSTMENT ∂/ƒ to select "LANGUAGE".
Then press ENTER to display the "LANGUAGE"
screen.
2. Press ADJUSTMENT ∂/ƒ to select the lan-
guage you want to display on the screen. Then
press ENTER. The On-screen Display is now
programed to display in the language selected.