Adjusting The Anti-Scalp Rollers - Toro 74912 Operator's Manual

Figure 24
Transport Lock Position
Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 1-1/2 to
4-1/2 inch (38 to 114 mm) in 1/4 inch (6 mm)
increments by relocating the clevis pin into different
hole locations.
1. Push on the deck lift pedal with your foot and raise
the mower deck to the transport position (also
the 4-1/2 inch (114 mm) cutting height position)
(Figure 25).
2. To adjust, remove the pin from the height-of-cut
bracket (Figure 25).
3. Select a hole in the height-of-cut system
corresponding to the height-of-cut desired and,
insert the pin (Figure 25).
4. Push on the deck lift pedal with your foot and raise
the height-of-cut lever slightly to disengage the
transport lock. Lower the deck slowly until the pin
makes contact with the lever.
G010016
1. Deck lift pedal
2. Cut height pin
3. Height-of-cut positions
Using the Lock Positions
G010219
The deck can be locked in the highest height-of-cut or
transport position or the lowest height-of-cut position.
1. Push on the deck lift pedal with your foot and raise
2. Remove the pin from the height-of-cut bracket
3. Select a hole on the lock decal and insert the pin
4. Push on the deck lift pedal with your foot and raise
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade control switch (PTO), move
2. Stop the engine, remove the key, and wait for all
22
1
4
G010236
Figure 25
the mower deck to the transport position (also
the 4.5 inch (114 mm) cutting height position)
(Figure 25).
(Figure 25).
(Figure 25).
the height-of-cut lever slightly to disengage the
transport lock. Lower the deck to slowly until the
pin makes contact with the lever.
the motion control levers to the neutral lock
position and set the parking brake.
moving parts to stop before leaving the operating
position.
5
3
2
4. Lock position. lowest
height-of-cut (use only for
deck removal)
5. Lock position. transport
position