Servicing The Fuses - Toro 74912 Operator's Manual

Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged.
This is especially important to prevent battery
damage when the temperature is below 32°F (0°C).
1. Charge battery for 10 to 15 minutes at 25 to 30 amps
or 30 minutes at 10 amps.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the
charger leads from the battery posts (Figure 47).
3. Install the battery in the machine and connect the
battery cables, refer to Installing the Battery.
Note: Do not run the machine with the battery
disconnected, electrical damage may occur.
Figure 47
1. Positive Battery Post
2. Negative Battery Post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
Fuses:
• Main, 30 amp, blade-type
• Engine, 20 amp, blade-type
1. The fuses are located on right hand console next to
the seat (Figure 48).
3. Red (+) Charger Lead
4. Black (-) Charger Lead
2. To replace the fuses, pull out on the fuse to remove
it.
3. Install a new fuse (Figure 48).
1. 30 amp
2. 25 amp
37
G010340
1 2 3
G010241
Figure 48
3. Fuse block