Table of Contents
Advertisement
Press and hold Favourite for ap-
▶
prox. 3 seconds.
Press Favourite to call up the
saved programme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
12.5 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 30
Requirements
The laundry is prepared and sor-
¡
ted.
→ "Laundry", Page 34
The drum is empty.
¡
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
12.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 34
Press
.
▶
The display shows the programme
a
duration or the programme end
time.
After the programme has ended,
a
the display shows: "End " .
Note: If "Hot" appears, the appli-
ance cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
12.7 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Press
.
1.
The cooling process starts auto-
matically after approximately 30
seconds and cools down the laun-
dry while the drum is rotating. If
you want to avoid or cancel the
cooling process, open the door.
→ "Display", Page 23
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
12.8 Cancelling the pro-
gramme
Press
.
1.
Open the door.
2.
Remove the laundry.
3.
→ "Unloading the laundry",
Page 35
12.9 Unloading the laundry
Open the door.
1.
Remove the laundry from the
2.
drum.
12.10 Put the appliance into
standby mode
Press
.
▶
12.11 Fluff filter
During drying, fluff from the laundry is
collected in the fluff filter. The fluff fil-
ter protects the appliance from fluff.
Cleaning the fluff filter
If the drying programme has finished
or the display shows a notification
while the appliance is in operation,
clean the fluff filter.
Note: If you do not clean the appli-
ance as described, the appliance's
functionality may be impaired.
Basic operation en
35
Advertisement
Table of Contents
