Trane A952V040BU3SB Installation, Operation And Maintenance Manual page 62

D D u u c c t t C C o o n n n n e e c c t t i i o o n n s s
I I n n s s t t a a l l l l a a t t i i o o n n I I n n s s t t r r u u c c t t i i o o n n s s
1. Remove the bottom plate.
2. Set the furnace on the base inside closet.
3. Install remote filter.
4. Seal per local codes and requirements.
5. Set the furnace on the filter box inside closet.
6. Must have grill present for air.
7. Set the furnace on the ducted pedestal. The ducted
pedestal will use ducted air from a remote location.
8. Install filter at a remote location.
9. Set the furnace on the filter box. The ducted
pedestal will use ducted air from a remote location.
10. Create ducting and set the furnace in place.
11. Match the filter cabinet flush to the back and
bottom sides of the furnace cabinet and secure in
place with screws.
12. Mark the two areas to be cut out for the return air.
62
13. Cut out the two sections of the cabinet and BAYLIFT
kit to be removed.
14. Attach ducting to the filter box.
15. The ducted pedestal will use ducted air from a
remote location.
16. Using guides, remove the cutout for the side return.
17. Create ducting and set the furnace in place. Use
screws to attach ducting to the furnace cabinet.
18. Seal bottom panel per local codes and
requirements.
19. Seal all other panels per local codes and
requirements.
20. Remove the top plate.
21. Attach the ducting to the top of the furnace.
22. Attach the plenum ducting to the top of the furnace.
23. Attach the filter box to the top of the furnace.
24. Attach ducting.
A952V-SVX001-1B-EN