Disposal - XTM XTM40 Operating Manual

Disposal

Fault
When operating from
the DC outlet:
The ignition is on
and the device is not
working and the LED
is not lit.
The display shows an
error message (e.g.
"Err1") and the appli-
ance does not cool.
The interior light of a
compartment flashes.
10 Disposal
➤ Place the packaging material in the appropriate recycling waste bins wherever
possible.
M
If you wish to finally dispose of the product, ask your local recycling centre
or specialist dealer for details about how to do this in accordance with the
applicable disposal regulations.
22
Possible cause
The DC outlet is dirty.
This results in a poor
electrical contact.
The fuse of the DC plug
has blown.
The DC fuse inside the
device has blown.
The vehicle fuse has
blown.
The appliance has
switched off due to an
internal fault.
The lid of the
compartment has been
left open for more than
three minutes.
Suggested remedy
If the plug of your cooler becomes very
warm in the DC outlet, either the DC
outlet must be cleaned or the plug has
not been assembled correctly.
Replace the fuse in the DC plug, see
chapter "Replacing the DC plug fuse" on
page 19.
This can only be repaired by an
authorized service agent*.
Replace the vehicle's DC outlet fuse.
Please refer to your vehicle's operating
manual.
This can only be repaired by an
authorized service agent*.
Close the lid of the compartment.
* contact details on page 21.
XTM40