XTM XTM40 Operating Manual page 16

Operation
6.5 Using the cooler
A
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. The cooler MUST maintain a MINIMUM of 50 mm
away from walls or similar surfaces which could restrict important air flow
requirements of the cooling system.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
NOTE
Place the cooler as shown (fig. 1, page 7). If you operate the box in a
different position it can be damaged.
➤ Close the cooler, see chapter "Connecting to a battery (vehicle or boat)" on
page 13.
I
NOTE
If you wish to operate the cooler from the AC power supply, set the
battery monitor to the "LOW" position.
➤ Press the "ON/OFF" button (fig. 3 1, page 10) for between one and two
seconds.
✓ The "POWER" LED lights up.
✓ The display (fig. 3 5, page 10) switches on and shows the current temperature.
I
NOTE
The temperature displayed is that of the middle of the interior.
The temperatures elsewhere can deviate from this temperature.
✓ The cooler starts cooling the interior.
I
NOTE
During low voltage:
If switched off by the battery monitor due to low voltage, the display
goes blank, and the LED "POWER" flashes orange.
16
XTM40