XTM XTM40 Operating Manual page 17

XTM40
Latching the cooler lid
➤ Close the lid.
➤ Press the latch (fig. 2 1, page 9) down, until it latches in place audibly.
6.6 Setting the temperature
A
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
➤ Press the "SET" button (fig. 3 4, page 10) once.
➤ Use the "UP +" (fig. 3 6, page 10) and "DOWN –" (fig. 3 7, page 10) buttons
to select the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
6.7 Using the Emergency Switch
The emergency override switch (fig. 4 4, page 11) is located in the connection
panel.
➤ For normal operation the switch should be in the NORMAL USE position.
➤ In the unlikely event of an electronic control failure slide the switch to
EMERGENCY OVERRIDE.
I
NOTE
In this position the appliance will run all the time and will therefore per-
form as a freezer only.
6.8 Switching off the cooler
➤ Empty the cooler.
➤ Switch the cooler off.
➤ Pull out the connection cable.
If you do not want to use the cooler for a longer period of time:
➤ Leave the lid slightly open. This prevents odor build-up.
Operation
17