VONROC S2 AG504DC Original Instructions Manual page 12

EN
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. C-1)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (13) into the base of the
machine as shown in Fig. C-1.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. C-1)
1. Push the battery unlock button (14).
2. Pull the battery out of the machine like shown in
Fig. C-1.
Checking the battery charging status (Fig. C-2)
• To check the battery charge status, push the
button (15) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more charge
the battery has left.
• When the lights are not burning it means the
battery is empty and must be charged immedia-
tely.
Charging the battery with the charger (Fig. C-2)
1. Take the battery (13) from the machine.
2. Turn the battery (13) to upside down position and
slide it onto the charger (17) as shown in Fig. C-2.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet and
wait for a while. The LED indicators on the charger
(18) will lighten up and show the charger status.
12
The charger has 2 LED indicators (18) which indicate
the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to 60
minutes.
• Fully charging the 4Ah battery may take up to 120
minutes.
After the battery is fully charged remove the charger
plug from the outlet and remove the battery from the
charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Assembling the protection guard (Fig. E and F)
1. Place the machine on a table with the spindle (7)
facing upwards.
2. Place the protection guard (3) over the machine
head as shown in Figure E making sure the ridges
on the protection guard fall into the notches of the
machine head.
3. Turn the protection guard counter clockwise and
secure the guard by tightening the screw.
Never attempt to remove the guard
Mounting and removing the wheel disc (Fig. D)
Do not use the machine without the guard.
Only use sharp and undamaged wheel discs.
• Always use suitable wheel disc for this machine
with diameter Ø 125 mm and a bore from
22.2 mm the thickness of the wheel disc should
be 6 mm for wheel disc for grinding and 3 mm for
wheel disc for cutting, the mounting wheel disc
may not touch the safety guard.
Charger status
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
Battery charging in
progress
WWW.VONROC.COM