MAJORITY BARD Instruction Manual page 19

No station is found.
No signal or hiss in
DAB/FM mode.
USB driver or MP3 player
is not detected.
Alarm does not work.
All other undetermined
cases. / Electro-Magnetic
Interference.
2. Place the device closer to the router.
3. Make sure the password is correct.
1. Check the network as well as the access point and
firewall.
2. The station may not be available currently, try
again later.
3. The link of the station is changed or the station no
longer transmits – ask the provider for information.
4. The link of manual added station may not be
correct, check and change it.
1.Check the antenna installation properly/move the
antenna. Also try to adjust the length of antenna.
2.Move the radio to other location.
1. Check if the USB driver or MP3 player is plugged
properly.
2. Some USB hard disks need external power supply,
make sure it is connected to the power.
3. Not all MP3 players can be read directly on the
device – use an USB drive instead.
1. Switch on the alarm.
2. Due to the volume setting, refer to the solutions
of "No sound".
3. The source of alarm was set to be station but
there is no network connection. Change the source
of alarm or reconfigure the connection.
The smart radio may process large amount of data
after a period of operation, no matter in which
mode, it will cause the system freeze or
malfunction.
Reboot the device if necessary.
The normal function of the product may be
disturbed by strong Electro-Magnetic Interference.
If so, simply reset the product to resume normal
operation by following the instruction manual. In
case the function could not resume, please use the
product in other location.
The device may malfunction when used in areas
with strong radio interference. The device will work
properly again once there is no more interference.
19