Using Device - Lenovo 3000 H220 Hardware Maintenance Manual

Using Device

3. The password dialog box will be displayed. Type the new password, and
press Enter.
4. when prompted to confirm the password, type the password again. If
you type the password correctly, the password will be installed.
To delete a previously set user password, do the following :
Note: When prompted for a password, you must type your supervisor
password.
1. From the Setup Utility program menu, select Set User Password and
press Enter.
2. when you type the user password. a message will display that Enter
New Password. Press Enter and a message will display that indicates the
password has been disabled.
3. Press any key to contine.
Device is used to enable or disable user access to the following device:
PS/2 Device
To set Device, do the following:
1. Start the Setup Utility program (see "Starting the Setup Utility program"
on page 16).
2. From the Setup Utility program menu, select Devices.
3. Select PS/2 Device.
4. Select PS/2 Mouse.
5. Select Disable, Enable or Auto and press Enter.
6. Return to the Setup Utility program menu and select Exit and then Save
changes and Exit.
Note: If you do not want to save the settings, select Discard Changes
and Exit or Discard Changes. You can set others such as Serial
Port Setup, USB Setup, ATA Drives Setup, Video Setup, Audio
Setup, Network Setup and so on. See the information displayed
on the right side of the screen.
When this feature is set to Disable, the
device of PS/2 Device is disabled and will
not be displayed in the system
configuration.
Chapter 5. Using the Setup Utility
31