Security Options - Lenovo 3000 H220 Hardware Maintenance Manual

press Enter.
4. when prompted to confirm the password, type the password again. If
you type the password correctly, the password will be installed.
To delete a previously set user password, do the following :
Note: When prompted for a password, you must type your supervisor
password.
1. From the Setup Utility program menu, select Change User Password
and press Enter.
2. when you type the user password. a message will display that Enter
New Password. Press Enter and a message will display that indicates the
password has been disabled.
3. Press any key to contine.

Security Options

After a Supervisor Password is set, the Security Options can be displayed
in the menu of Security.
To set Security Options, do the following:
1. Start the Setup Utility program (See "Starting the Setup Utility
program".)
2. From the Setup Utility program menu, selet Security.
3. Select Change Supervisor Password.
4. Set the Supervisor Password .
5. After that, Select Security Option.
6. Select Setup or Always and press Enter.
7. Return to the Setup Utility program menu and select press ESC to
return the Security or press F10 to Save configuration changes and exit
setup.
Notes:
a. If you choose Setup of the Security Options, the Setup Utility
program does not display until you type your password. But you can
start other programs without the password.
b. If you choose Always of the Security Options, You can't start any
program until you type your password.
Chapter 5. Using the Setup Utility
25