Table of Contents
Advertisement
DEMO MANUAL DC2654A
QUICK START PROCEDURE
Refer to Figure 1, Figure 2 and Figure 3 for the proper
equipment setup. Follow the procedure below to familiar-
ize yourself with the DC2654A.
STANDALONE PROCEDURE
1. Connect a voltmeter (VM1) across the V
GND turrets.
2. Plug your USB Type-C power adapter into J1 on the
DC2654A.
3. Observe the voltage on VM1 go to 5V and then to the
negotiated voltage (if there is one). The LED on the
DC2654A will light as soon as power is delivered to
the VM1 node.
Figure 1. DC2038A is a Battery Charger Demo Board for
the LTC4162 Designed to Interface with DC2654A.
Figure 2. DC2654A Mounted Onto DC2038A
2
DEMO BOARD PROCEDURE
1. If the demo board is designed to interface with
DC2654A, follow any instructions in that board's demo
manual before continuing. If you need to program the
DC2654A, refer to the Programming Instructions sec-
and
tion in this manual.
OUT
If the board is not designed to interface with DC2654A,
you can continue, but be sure that the adapter used does
not offer a higher profile than the board can withstand.
2. Connect a voltmeter (VM1) across the V
GND turrets. Connect DC2654A to the demo board
under test.
4. Plug your USB Type-C power adapter into J1 on
the DC2654A.
5. Observe the voltage on VM1 go to 5V and then to the
negotiated voltage (if there is one). The LED on the
DC2654A will light as soon as power is delivered to
the VM1 node.
Figure 3. The Banana Plugs and Header on DC2654A Will
Fit Snugly Into Compatible Demo Boards.
and
OUT
Rev. 0
Advertisement
Table of Contents
