Fcc And Industry Canada Compliance - Victron energy SmartSolar MPPT 150/60 Manual

This device contains a transmitter with FCC ID: SH6MDBT42Q.
This device contains a transmitter with IC: 8017A-MDBT42Q.
To comply with FCC and Industry Canada RF radiation exposure limits for general population, the antenna(s) used for this
transmitter must be installed such that a minimum separation distance of 20cm is maintained between the radiator (antenna) and
all persons at all times and must not be co-located or operating in conjunction with any other antenna or transmitter.

1.5. FCC and Industry Canada Compliance

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device contains a transmitter with FCC ID: SH6MDBT42Q.
Page 3
MPPT solar charger manual
Safety precautions