Symbols Used On The Enclosure; Smartsolar Mppt 150/35 Fcc And Industry Canada Compliance - Victron energy SmartSolar MPPT 150/60 Manual

1.3. Symbols used on the enclosure

The following symbols are used on the solar charger enclosure:
Symbol Name
Danger of electric shock
warning
Hot surface warning
Read the manual
instruction
Ingress protection value
Ground symbol

1.4. SmartSolar MPPT 150/35 FCC and Industry Canada Compliance

This device complies with part 15 of the FCC Rules and to RSS of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial
environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. Operation of this equipment in a residential area may cause radio
interference, in which case the user may be required to take adequate measures. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de Classe A est conforme à la norme Canadienne ICES-003.
Page 2
MPPT solar charger manual
Meaning
Do not touch the electric connections, there is danger of electrical shock.
Do not touch the surface of the appliance, while it is running, it will get hot.
Read the product manual before installation and use.
IP43 - The electronic components are protected from tools and small wires
greater than 1 millimetre and protected from water spray less than 60 degrees
from vertical.
Indicates the position of the chassis ground connection
Safety precautions