Table of Contents
Advertisement
5
4
REASSEMBLY
u
Smear a layer of grease all along the wheel
shaft (5), see page 93 (LUBRICANT
CHART).
CAUTION
While reassembling the wheel, be careful
not to damage the brake pipes, discs and
pads.
u
Position the wheel between the fork legs on
the support (1).
CAUTION
Proceed with care while inserting the disc
in the brake calliper.
WARNING
Danger of injury. Do not insert your
fingers to align the holes.
u
Move the wheel until its central hole and
the holes on the fork are aligned.
u
Set one of the two spacers between wheel
hub and fork right leg.
u
Position the other spacer between the
wheel hub and the fork left leg.
u
Push the wheel shaft (5) fully home from
the right side.
u
Tighten the wheel shaft clamp bolts to the
right (4).
u
Tighten the wheel shaft nut (3).
u
Tighten the wheel shaft clamp bolts to the
left (6).
u
Loosen the wheel shaft clamp bolts to the
right (4).
u
Press on the front end to settle the fork
legs.
u
Tighten the wheel shaft clamp bolts to the
right (4).
Wheel nut tightening torque (3): 80 Nm (8
kgm).
R e m o v e t h e s u p p o r t ( 1 ) t h a t u p o n
disassembly was put under the tyre.
Refit the brake calliper and tighten the
retaining screws (2).
Brake calliper screws (2) tightening
torque: 50 Nm (5 kgm).
Due to the weight and dimensions of the
vehicle, the following operation must be
performed by two persons.
NOTE
Weight without rider: 180 kg.
WWW.PlandeGraissage.ORG
4
2
3
WARNING
u
Remove the front support stand, see page
67 (POSITIONING THE VEHICLE ON THE
FRONT SUPPORT STAND
u
Remove the rear support stand, see page 67
(POSITIONING THE VEHICLE ON THE
REAR SUPPORT STAND
u
With pulled front brake lever, press the
handlebar repeatedly, thrusting the fork
downwards. In this way the fork legs will
settle properly.
u
Position the vehicle on the stand, see page
55 (POSITIONING THE VEHICLE ON THE
STAND).
u
Tighten the wheel shaft clamp bolts (4) on
either side.
Wheel shaft clamp screws tightening
torque (4): 12 Nm (1.2 kgm).
u
Make sure that the following components
are not dirty:
– tyre;
– wheel;
– brake disc.
WARNING
After reassembly, pull the front brake
lever repeatedly and check the correct
functioning of the braking system.
Have the tightening torques, centring and
balancing of the wheel checked by an
aprilia Authorised Dealer
avoid accidents that may be harmful for
you and/or other people.
use and maintenance Pegaso 650 I.E. STRADA - TRAIL
).
).
, in order to
63
Advertisement
Table of Contents
