Bosch HLS79W3 0U Series Instruction Manual page 42

Appliance door
en
Unscrew the retaining clips on the right and left. Lift
4.
the panel and remove the clips from the panel
(fig. C).
Remove the seal from the bottom of the panel (fig.
5.
D). Pull the seal and remove it up and out. Pull out
the panel.
Pull the lower panel at an angle, upwards and out.
6.
Do NOT unscrew the left and right-hand screws from
7.
the sheet metal part (fig. E).
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Installation
During installation, make sure that the lettering "right
above" is upside down at the bottom left of both panels.
Insert the lower panel at an angle towards the back
1.
(fig. A).
Slide in the middle panel (fig. B).
2.
42
Stick the retaining clips onto the right and left-hand
3.
side of the panel, aligning them so that the retaining
carriers are over the screw holes, and then screw
into place (fig. C).
Hook the seal in to the bottom of the panel again
4.
(fig. D).
Insert the uppermost panel at an angle to the back
5.
into the brackets. Take care not to push the seal to
the back (fig. E).
Insert the two small seals on the left and right of the
6.
panel again (fig. F).
Put the cover back in place and screw it on.
7.
Attach the oven door.
8.
Do not use the oven again until the panels have been
correctly installed.