Table of Contents
Advertisement
PowerBoost function
en
Notes
To set a cooking time of under 10 minutes, always
■
touch 0 before you select the required value.
If a cooking time was programmed for several
■
hotplates, the time information for the selected
hotplate is shown in the timer display.
Select the relevant hotplate to call up the remaining
■
cooking time.
You can set a cooking time of up to
■
The kitchen timer
You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Setting
Touch the
symbol repeatedly until the
0
1.
indicator lights up.
‹‹
Set the desired time in the settings area.
2.
After a few seconds, the time begins to elapse.
Changing or deleting the time
Touch the
symbol repeatedly until the
0
lights up.
Change the time in the settings area or set
to delete the programmed time.
When the time has elapsed
An audible signal sounds.
display and the
indicator lights up. The displays go
V
out after 10 seconds.
When the
symbol is touched, the displays go out
0
and the audible signal ceases.
24
minutes.
ŠŠ
V
lights up on the timer display.
indicator
V
in order
‹‹
appears on the timer
‹‹
vPowerBoost function
T he PowerBoost function enables you to heat up large
P o w e r B o o s t f u n c t i o n
quantities of water faster than when using heat
setting
.
Š
The function can be used by any hotplate provided that
no other hotplates are switched on. Otherwise
will flash in the heat setting display.
Activation
Select a hotplate.
1.
Touch the
symbol.
á
2.
lights up on the display.
›
The function is activated.
Notes
If a hotplate is switched on while the PowerBoost
■
function is active,
›
setting display; heat setting
automatically. The PowerBoost function will now be
deactivated.
In the combi zone, the PowerBoost function can only
■
be activated if the two hotplates are being used
independently of each other.
Deactivation
Select the hotplate.
1.
Touch the
á
symbol.
2.
The
display goes out and the hotplate switches
›
back to the
heat setting.
Š
The function is deactivated.
In certain circumstances, the PowerBoost
Note:
function can switch itself off automatically in order to
protect the electronic elements inside the hob.
and
will flash on the heat
Š
will then be applied
Š
and
›
Š
Advertisement
Table of Contents
