Sanyo VSP-8500 Instruction Manual page 10

Part names (Continued)
Rear
① Power terminal (DC 12V)
Connect the DC terminal to the AC adapter
provided.
② Dip switch (SW)
Use these settings when using this unit as a system
controller. (OFF)
SW
These switches are used to set
each terminal setting ON or OFF.
1 2 3 4
(Terminal switch)
ON
These settings are used when upgrading the system on
this unit using a PC.
③ PC connection terminal
(COM: RS-232C)
This terminal is used to connect to a PC.
9
Preparations
1 2 3 4
ON
① ② ③
④ Camera communication terminal
(TELEMETRY A/B)
Use the modular cable, accessory or sold
separately, and the communication conversion
connector, included, to connect to this terminal.
• Terminal A: Connects to the camera cable.
• Terminal B: Connects to the camera cable.
⑤ Video communication terminal (VIDEO)
Use the modular cable, included or sold separately,
and the communication conversion connector,
included, to connect the video device, i.e. DVR, to
this unit.
④/⑤ : RS485 (RJ-11) terminal
Signal B
④ ⑤
Signal A