Sanyo RCS-KS2432AWD Installation Instructions

03-242.Sanyo.85464359404000
RCS-KS2432AWD
Parts supplied with remote controller
See Table 1.
Remote controller installation guidelines
Installation location
• Mount the remote controller 1 to 1.5 meters off the
floor where it can sense the average temperature of
the room.
• Do not mount the remote controller in a place
exposed to direct sunlight or where it is exposed to
outside air such as near a window.
• Do not mount the remote controller behind a curtain
or other object so that it is separated from the air cir-
culation of the room.
• Mount the remote controller inside the room being air
conditioned.
• The remote controller should be mounted on a wall or
other surface vertically.
Switching the room temperature sensor
Room temperature sensors are separately incorporated
in both the indoor unit and the remote controller. Either
sensor can be used to sense the room temperature. The
indoor unit sensor is usually used.
If you wish the remote controller to sense the room tem-
perature, press the SENSOR button with a ballpoint pen
or tool with a small tip.
How to install the remote controller
<NOTE 1> Do not twist the remote controller wire
with the power cord, or run them in the
same metal conduit, because this may
cause a malfunction.
<NOTE 2> Install the remote controller away from all
sources of electrical noise.
<NOTE 3> Install a noise filter or take other appro-
priate action if electrical noise affects the
power supply circuit of the unit.
• Use an electric junction box (supplied locally) for
embedded mounting of the remote controller.
(See Fig. 1)
85464359404000 © SANYO 2003
8/21/03 9:17 AM Page 1
INSTALLATION INSTRUCTIONS
Table 1
No. Supplied parts Q'ty
Remote
controller
1
(comes with
200mm wire)
Machine screws
M4 25
2
Tapping screws
M4 25
2
Spacers
2
Note: Remote controller model name RCS-KS2432AWD
Code: 851-0-0054-590-00-0
Under-case (back case)
Spacers
Remote controller
Lead wires (3)
Machine screws
M4 25 (2)
Fig. 1
No. Supplied parts Q'ty
Wire joints
6
Harness
1
Clamper
1
Instruction manual
1
Wall
Electric junction box
(no cover)
W