Emerson 475 User Manual page 72

72
6.Select Yes or No when you are asked if the device is commissioned.
You cannot change the physical device tag or address if the device is
commissioned.
7.Using the SIP keyboard, enter the new information. When you
modify a parameter value, an asterisk (*) appears and the value is
highlighted yellow to indicate the change has not been sent to the
device.
8.Tap OK.
9.Tap SEND to send the changes to the device. A window appears
until the changes are made.
10.Tap YES, if prompted.
Displaying network settings
To view the network parameters for the device or segment:
1.Display the Live Device List; see page 65.
2.Double-tap a device.
3.Double-tap Advanced.
4.Double-tap Network Management.
5.Double-tap the desired label to view the values.
Tap the SAVE button to save this as a text file. Connect your 475 Field
Communicator to the Field Communicator Easy Upgrade Utility to
transfer this file to a PC. The file appears in the User Data tab.
Changing the I/O block schedule
Changing the I/O Block Schedule is typically done on the bench (not
connected to a control system) when you want to execute an I/O block
to verify that the outputs of the block are computed correctly.
NOTE
You cannot schedule I/O blocks when the device is commissioned or,
at a minimum, any of the following hosts/linking devices are detected
on the segment: Rosemount 3420, DeltaV, Ovation, Allen-Bradley
FFLD and FFLDC, Honeywell Experion PKS, Yokogawa Stardom or
CENTUM, Softing FG-100/HSE, or SMAR DF62. To schedule I/O
blocks, use the host system or remove the device from the segment
and connect it directly to the 475 Field Communicator.
To change the schedule:
1.Display the Live Device List; see page 65.
2.Double-tap a device.
3.Double-tap Advanced.
4.Double-tap Schedule.
5.Select Yes or No when you are asked if the device is commissioned.
You cannot schedule blocks if the device is commissioned.
6.Select the appropriate MacroCycle from the drop-down list.
Fieldbus functionality