Table of Contents
Advertisement
Fixture
Screw
Keyhole
Slot
Install the included bulb into
the socket. When necessary,
replace with bulb of same
wattage.
Ceiling Bracket
Downrod
Installing the Light Fixture
bag
Empty Post
Partially install three fixture screws, found
in the
hardware bag, into the posts as
shown, leaving the circled post empty.
Align the three keyhole slots in the light kit
with the three assembly screws in the posts.
Lift the light kit and twist counterclockwise
to lock it into place. Be sure that both pull
chains are hanging freely.
Tab
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan
3 of 7
Fixture Screw
Installing the Glass
Notch
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Wiring
Canopy
Connect the plugs from the upper and
lower switch housings. Make sure to
line up the colored markings on the
connectors and that the connectors latch.
This is the screw you saved that
was attached to the red flag.
bag
Install the fourth fixture
screw and tighten all four
screws securely.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades
Light
1886
1 of 7
Fixture Screw
ON
8
Glass/Bulbs
Advertisement
Table of Contents
