Installing The Light Fixture - Hunter Barnes Bay Installation Manual

1886
Empty Post
Partially install three fixture screws
with washers, found in the
hardware bag, into the posts as shown,
leaving the circled post empty.
9
Ceiling Bracket Downrod

Installing the Light Fixture

3 of 4
Fixture Screw
(With Washer)
bag
Fixture
Screw
Keyhole
Slot
This is the screw you saved that
was attached to the red flag.
Fixture Screw
(With Washer)
bag
Install the fourth
fixture screw (with
washer) and tighten all
four screws securely.
Hanging Fan Wiring
Align the three keyhole slots in the
light kit assembly with the three
assembly screws in the posts.
Lift the light kit assembly and
twist counterclockwise to lock it
into place. Be sure that both pull
chains are hanging freely.
1 of 4
Make sure the light kit assembly is securely
attached to the light fixture hood. Failure to
properly secure all four assembly screws could
result in the light kit assembly falling.
Canopy Blades
Connect plug to the light kit assembly.
Make sure to line up the colored
markings on the connectors and that the
connectors latch.
Install the bulb into the socket.
When necessary, replace with
bulb of the same wattage.
IMPORTANT
Hood Light Fixture Pull Chains Glass/Cage