Sanyo CHDZ07263 Service Manual page 44

3. Timer Remote Controller
4. Set the program pattern.
(program step 3)
There are 4 program patterns.
Pressing /
Pattern 1
The indoor unit starts operation at the programmed
time.
Pattern 2
The indoor unit stops operation at the programmed
time.
Pattern 3
The indoor unit starts operation at the programmed
time and changes the temperature settings.
Press /
Pattern 4
The indoor unit changes the temperature setting at
1
the programmed time.
Press /
2
Select the program pattern and press
NOTE
If you press
3
If there is no operation made for 3 minutes during the setting, it returns to the normal mode.
In this case, all the settings in progress will be invalid.
4
5
6
7
repeats the following display patterns.
to change the temperature setting.
to change the temperature setting.
. The program timer setting is confi rmed and the unit enters the confi rmation mode
during the setting, it returns to the program confi rmation mode.
Pattern 1
Pattern 2
Pattern 3
Pattern 4
2 - 24
Remote Control Functions
.