Table of Contents
Advertisement
3
Connect the AC adapter to the
on the projector.
4
Connect the power cable to an electrical
socket.
•
The LED on the projector lights up in
red.
AV
d
a
Prepare the remote controls
CAUTION!
The improper use of batteries can
lead to overheating, explosion, risk of
fire and injury. Leaking batteries can
possibly damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or
charging the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1
Open the battery compartment.
2
Insert the supplied batteries (type AAA)
with correct polarity (+/- ) indicated.
3
Close the battery compartment.
•
When using a remote control with infrared
signals, point the remote control at the IR
Initial setup
socket
MICRO SD
HDMI 1
HDMI 2
USB
DC
c
b
sensor on the projector, and make sure
there is no obstacle between the remote
control and the IR sensor.
Power on and set up the
projector
1
Press
to turn on the projector. The LED
on the projector turns from red to green.
•
To turn off the projector, press
projector enters standby mode and its LED
turns from green to red. To fully shut down
the projector, disconnect the power cable
from the electrical socket.
•
The distance between the projector and the
projection surface determines the actual
screen size.
Screen size adjustment
The projection screen size (or size of images) is
determined by the distance between the lens
of the projector and the projection surface.
This projector has a maximum projection
distance of 254 cm (100"), and thus creates a
maximum screen size of 80" (203 cm).
Digital zooming
You can use the digital zooming to reduce the
screen size.
1
Press
on the projector remote control to
access the setup options and go to Digital
Zoom.
Press / or the OK button to adjust the
2
screen size.
Screen height adjustment
To adjust the screen height when placing
the projector on a flat surface, turn the angle
adjustment knob located at the bottom of the
projector.
twice. The
9
Advertisement
Table of Contents
