Table of Contents
Advertisement
Prepare the remote control
CAUTION!
The improper use of batteries can lead
to overheating, explosion, risk of fire and
injury. Leaking batteries can possibly
damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or charging
the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1
Open the battery compartment.
2
Insert the supplied batteries (type AAA)
with correct polarity (+/- ) indicated.
3
Close the battery compartment.
Notice
When using the remote control, point the
remote control at the IR sensor located
on the back of the projector, and make
sure there is no obstacle between the
remote control and the IR sensor.
Power on and setup
1
Press and hold
on the remote control) for 1 second to
switch the projector on or off.
•
When the projector is switched on, the
LED on the projector turns blue if the
projector is not being charged.
•
When charging, the LED on the
projector turns red regardless of the
projector switching on or off.
Initial operation
on the projector (or
Change screen size
The projection screen size (or size of images) is
determined by the distance between the lens
of the projector and the projection surface.
•
The projection distance needs to be 1.2
times the width of your desired screen size.
•
You can also use the digital zoom to reduce
the screen size up to 80%. On the home
screen, select
home screen, and press OK, then go to
Projector Settings - Image - Digital Zoom.
Image focus adjustment
Auto focus adjustment
The projector can automatically adjust image
focus or clearness when you reposition the
projector or the projected image is detected not
clear.
To enable auto focus adjustment, select
the upper right of the home screen, and press
OK, then go to Projector Settings - Image -
Autofocus Settings.
Manual focus adjustment
Press
on the remote control to turn focus
adjustment on, then press / on the remote
control to adjust image clearness. After
adjusting image clearness, press
focus adjustment off.
on the upper right of the
to turn
on
9
Advertisement
Table of Contents
