9.4.1 Arrow selection
>
If
is shown on the left and
alter this using the left/right arrow buttons.
9.4.2 Selection list
>
If
is shown on the right next to the set value, the value is altered via
the selection list. As an example below, the OSD font size is changed from
"normal" to "small".
>
Move the highlight onto the corresponding item and press the OK button to
open the selection list:
>
Highlight the desired setting using the up/down arrow buttons.
By pressing the up/down arrow buttons it is possible to move the highlight
from line to line, and to move upwards and downwards page by page using
the page up/down buttons.
>
Confirm by pressing the OK button. The selection list closes again and the
selected setting is shown in the menu.
on the right next to the set value, you can
DE
EN
77
Need help?
Do you have a question about the DIGIT ISIO S3 and is the answer not in the manual?