Advertisement
Replace the capacitor
1. Cut off the power
2. Open the machine rear cover
3. Unclamp the connction wire
4. Take out the capacitor (or open the capacitor fixer)
5. Re-install the capacitor in opposite course
Replace reducer
1. Cut off the power
2. Screw off the pulsator screws,take out the pulsator
3. Open the machine rear cover,remove the belt,loose the spin tub screws
4. Place the protection cushion on the ground
5. Turn over the machine ,make the machine base upside and keep it placidly
6. Screw off the screws on both base and pipe,let the base totally depart from the cabinet
7. Screw off the reducer screws,take out the reducer
8. Re-install the reducer in opposite course
Replace the wash motor
1. Cut off the power
2. Open the machine rear cover,remove the belt
3. Unclamp three wires of wash motor to connect
4. Screw off the spin tub screws
5. Place the protection cushion on the ground
6. Turn over the mahcine, make the machine base upside and keep placidly
7. Screw off the screws both base and pipe,let the base totally depart from the cabinet
8. Take out the power cord from the clip, which fix the wires
9. Take out the base, put it on the working table and keep placidly
10. Screw off the upper three fixed screws
11. Take out the spin motor assembly
12. Screw off the shaft screws, and take it out
13. Screw off three screws of brake plate, and take out the brake plate
14. Take out the spin motor
15. Re-install the spin motor in opposite course
Clean the foreign matters under the pulsator
1. Cut off the power
2. Screw off the pulsator and take it out
3. Turn over the pulsator, and clean the foreign matters inside the pulsator and meanwhile take out the
foreign matters on the tub bottom
4. Re-install the pulsator in opposite course
Clean the foreign matters on the spin tub shaft
1. Cut off the power
2. Open the panel frame,screw off the screws off middle frame, and take out th middle frame
Advertisement
