Advertisement
The screen will display a small green icon next to the zone name for a short time and also
display 'SENSOR PAIRED!' when the process is completed.
Press 'next' button to pair additional sensors.
Step 5: After pairing all sensors please select save. The below screen will then show all
zones and sensors that are paired.
*Additional steps if needed:
Not sure which WSPB10 is linked/paired to which zone?
press the push button on your wall sensor and a
linked to.
Linked/paired a sensor to the wrong zone?
Press the zone button that you want to unpair. It will pop up an 'unpair' button. Press the
'unpair' button and it is now ready to be paired to a different zone.
If you try to pair a sensor that is already paired to a zone on your system.
This message will be displayed when you press the push
button on the WSPB10 if it is already paired to another
zone. You have the option here to unpair and then pair again
in one step. Press 'yes' if you want to move it to this zone, if
not press 'no'.
will appear next to the zone name it is
Advertisement
