Advertisement
ii. Pair the sensor using the touch screen panel.
Please follow the 'How to pair WSPB10 for each zone' process shown in the
last page.
b. Wired - Set the zone number by flicking the appropriate switch on (eg if you
would like to set a sensor as zone 6 you would flick only switch 6 ON.)
10. Open the Advantage Air app on the home page of the touch screen
11. Press the SETUP button
12. Press the TECH SETUP button.
13. Enter password 22369 to access the setup.
14. Press Run Wizard, and follow the prompts on the screen.
*MyAir+ to interface with Mitsubishi City Multi – VRF systems
How to set it up
• VRF system includes 1x ME outdoor unit, and multiple ME indoor units.
• MyAir+ allows you to connect up to 4 indoor units together with one MyAir+ touch
screen.
• You need one CB10 ME per ME indoor unit.
• Follow the MyAir+ installation instructions.
• The Wall Mounted Touch Panel (TSPx) must be plugged into master Control Box (CB10
ME) .
• Note: On the TSPx the CBs are in order of the "aircon UID" (visible in the tech setup
tab, this setting is not editable). The Master CB is not always shown first.
*
How to pair WSPB10 for each zone.
Step 1: Remove the wall sensors from the packaging and discard the battery tab. Write the
zone number and name on the white area provided.
Step 2: Take the wall sensors to the wall mounted touch screen, go to MyAir tab -> Setup ->
zones and sensors.
Step 3: Select the correct zone WSPB10. Change the zone name on the TSP to match the
WSPB10 and press the
Step 4: Using your wall sensor (WSPB10), press and hold the push
button inside the temp sensor for 6 seconds (LED(D1) light will start
blinking) to pair with the touch screen. *It can take up to 12 seconds for
the pairing to register on the touch screen.
button on the touch screen.
Advertisement
