Do's And Don'ts - Water Tech Reionator Pro Ultra RXU13 Owner's Manual

DO'S AND DONT'S
DO ALWAYS
•
connections and placement of the system before installation.
DO
• install the Reionator Pro® Ultra system into the existing cold water supply line before
the water heater and before any cold water outlet that requires treatment.
DO
• bypass your system in the event of a water or plumbing related emergency.
DO
• decrease your usage of all cleaning products such as: soap, detergents, shampoo, etc.
Most homes can reduce their use of these products by 50% to 75% because they work
more efficiently in Reionator Pro® Ultra conditioned water.
DO
• inspect the brine tank monthly.
DO
• initiate a regeneration manually if high water usage is expected due to guests, heavy
laundry or other reasons.
DO
• contact your WaterTech Dealer if you have any questions about the operation of your
system or water quality issues.
DO
• enjoy all the benefits of your Reionator Pro® Ultra conditioned water!
DO NOT
•
or put a strain on plumbing and electrical connections.
DO NOT
•
DO NOT
•
system has been factory or field programmed specifically for your application.
• DO NOT
overfill the brine tank with salt. Approximately 6 inches below the rim is the
maximum recommended fill.
• DO NOT
extreme temperatures (below 40° F or above 110° F).
• DO NOT
use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
check your state and local regulations regarding plumbing and electrical
hang or stack items on your equipment. This may cause an equipment imbalance
disconnect or remove any part of the plumbing or electrical cord.
attempt to reprogram your system (except for the time clock setting). Your
allow your Reionator Pro® Ultra and attached plumbing to be exposed to
2