NordicTrack NTBE19.1 User Manual page 9

8. Pull the indicated Adjustment Knob (8), insert
the Seat Bracket (12) through the front bracket
(C) on the Frame (1), and then release the
Adjustment Knob into one of the adjustment
holes in the Seat Bracket.
Next, position the Seat Frame (4) between the
U-bracket (B) on the Frame (1) and the Backrest
Frame (3).
See the inset drawing. Attach the Bracket Stop
(20) to the Seat Bracket (12) with an M6 x 10mm
Screw (25).
Note: To adjust the Seat (5), see ADJUSTING
THE SEAT on page 10.
9. Using a plastic bag to keep your fingers clean,
apply some of the included grease to an
M12 x 130mm Bolt (29).
Insert the M12 x 130mm Bolt (29) through the
U-bracket (B) on the Frame (1), through the Seat
Frame (4), and through the Backrest Frame (3).
Then, tighten an M12 Locknut (24) onto the Bolt.
Do not overtighten the Locknut; the Seat
Frame and the Backrest Frame must pivot
freely.
See steps 3 and 5. Tighten the two M10
Locknuts (23) in each step.
10. Make sure that all parts of the weight bench are properly tightened. Extra parts may be included. Place a
mat under the weight bench to protect the floor.
To register your product and activate your warranty today, go to my.nordictrack.com.
8
5
12
1
9
24
9
4
3
B
8
C
12
20
25
3
4
1
29
B
Grease