Practice Fire Safety; What To Do In Case Of A Fire - Kidde FIREX 4985 User Manual

(For Models 4881 and 4985 only):
NOTE: Rechargeable lithium batteries are permanently mounted and
sealed in the tamper-proof housing. These cells are designed to
last the useful life of the smoke alarm.
1. Turn off power to smoke alarm at main consumer panel.
2. Insert a small screwdriver into the slot in the mounting plate. Depress
locking tab with the screwdriver and turn smoke alarm counter-clock-
wise to detach from mounting plate.
3. Gently pull down smoke alarm. Be careful not to separate cable
connections.
4. Pull out power plug from back of smoke alarm.
5. From back of smoke alarm, lift tab to open battery pocket door.
6. Remove battery from pocket. Disconnect and discard drained battery
from battery connector.
7. Connect a fresh, 9-volt battery to connector. The battery will fit only
one way. Be sure battery connector is securely attached to battery
terminals. Smoke alarm may sound a short beep when battery is
installed. This is normal and means the battery is installed correctly.
8. Place battery into battery pocket.
9. Close battery pocket door. Push down until it snaps into place.
10. Press and hold test button. The alarm will sound if the battery is
properly connected and working.
11. Replace connector plug. Connector will snap into place. Gently tug
connector to be sure it is attached properly.
12. Reattach smoke alarm to mounting plate by turning smoke alarm
clockwise until it snaps into place.
13. Turn on power and test smoke alarm using test button.
CLEANING
Clean the smoke alarm at least once a month to remove dust, dirt, or
debris. Always turn off power to smoke alarm before cleaning.
•
Using the soft brush or wand attachment to a vacuum cleaner, vacuum all
sides and cover of smoke alarm. Be sure all the vents are free of debris.
•
If necessary, turn off power and use a damp cloth to clean smoke
alarm cover.
IMPORTANT: Do not attempt to remove the cover or clean inside the smoke
alarm. THIS WILL VOID YOUR GUARANTEE.
REPAIR
!
CAUTION: Do not attempt to repair this smoke alarm.
If smoke alarm is not operating properly, see "Troubleshooting". If
necessary and if still under guarantee, return smoke alarm to Kidde.
Pack it in a well-padded carton and send, postage prepaid to Kidde
address at the end of this manual.
If the smoke alarm is no longer under guarantee, have a qualified
electrician replace the smoke alarm immediately with a comparable
Firex smoke alarm.
If the smoke alarm sounds its alarm horn, and you have not
pushed the test button, it is warning of a dangerous situation.
Your immediate response is necessary. To prepare for such
occurrences, develop family escape plans, discuss them with
ALL household members, and practice them regularly.
•
Expose everyone to the sound of a smoke alarm and explain
what the sound means.
•
Decide on TWO exits from each room and an escape route
to the outside from each exit.
• Teach all household members to touch the door and use an
alternate exit if the door is hot. INSTRUCT THEM NOT TO OPEN
THE DOOR IF THE DOOR IS HOT.
•
Teach household members to crawl along the floor to stay below
dangerous smoke, fumes, and gases.
• Decide on a safe meeting place for all members to meet outside the
building.

WHAT TO DO IN CASE OF A FIRE

1. Don't panic; stay calm.
2. Leave the building as quickly as possible. Touch doors to feel if
they are hot before opening them. Use an alternate exit if neces-
sary. Crawl along the floor, and DO NOT stop to collect anything.
3. Meet at a pre-arranged meeting place outside the building.
4. Call the fire brigade (Dial 999) from OUTSIDE the building.
5. DO NOT GO BACK INSIDE A BURNING BUILDING. Wait for
the fire brigade to arrive.
These guidelines will assist you in the event of a fire. However, to
reduce the chance that fires will start, practice fire safety rules and
prevent hazardous situations.
Doing so will void your guarantee.

PRACTICE FIRE SAFETY

6