Coin-Cell Battery; Removing The Coin-Cell Battery - Dell 0D8MH Service Manual

Steps
1. Using the alignment posts, place the battery on the palm-rest and keyboard assembly.
2. Lift the Mylar to access the battery connector and connect the battery cable to the system board.
3. Place the Mylar over the M.2 solid-state drive.
4. Replace the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in

Coin-cell battery

Removing the coin-cell battery

Prerequisites
1. Follow the procedure in
CAUTION: Removing the coin-cell battery resets the BIOS setup program's settings to default. It is
recommended that you note the BIOS setup program's settings before removing the coin-cell battery.
2. Remove the base cover.
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
About this task
The following image(s) indicate the location of the coin-cell battery and provides a visual representation of the removal
procedure.
30 Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Before working inside your