Table of Contents
Advertisement
APPENDIX B - MAINTENANCE
IMPORTANT: The DR Series Ozone Generator has electrical and mechanical hazards. Maintenance or repair should
not take place unless all energy sources have been turned off, disconnected, and/or drained.
Maintenance Table
Component
Ozone Cell
Inlet Filter
The DR-5 is designed to operate continuously with little to no maintenance. If the unit does not produce its
maximum ozone output, the following cleaning process can be performed:
• Unplug the DR-5 from its power source and re-move end cap.
• Use a compressed air source of no more the 100 PSI to remove any debris from the ozone block. Keep the
wand six inches away to prevent damage.
• The same air source can then be used to clean the four 3 ¼ inch particulate filters located on the sides of the
unit. If the particulate filters need replacement, contact Ozone Solutions.
• Once a month, after heavy use or after using in high humidity, the ozone block should be cleaned. To clean the
ozone block, remove the rivets that hold on the end cap. (This is the end of the generator that the air blows
out of.)
• A razor blade can be used to lightly scrape off the acidic crust buildup on the ozone block tubes.
Ensure that the unit is properly operating before resuming the ozonating process. If any failure should occur please
contact Ozone Solutions.
10
/
DR SERIES
Action
Time Period
Clean
1 month or as needed
Clean/Replace
3 months or as needed
Part Numbers
N/A
Foam Filter Replacement
Advertisement
Table of Contents
