Table of Contents
Advertisement
8.
Inspect the condition of the wheels. If the wheels
show signs of wear, replace them at this time.
9.
Beginning at the drive sprocket, coil the new
track around the sprocket, ensuring that the
lugs on the track fit between the spacers on the
sprocket
(Figure
10.
Push the track under the lugs and between the
road wheels
(Figure
11.
Starting at the bottom of the front wheel, install
the track around the wheel by rotating the track
rearward while pushing the lugs into the wheel.
12.
Tension the track; refer to
Tension (page
30).
13.
Lower the machine to the ground.
14.
Repeat steps
3
through
track.
Servicing the Drive Belt
Inspecting the Drive Belt
Service Interval: Every 100 hours
1.
Park the machine on a level surface, move
the motion-control levers to the N
position, engage the parking brake, and lower
the hopper.
2.
Shut off the engine, and remove the key. Allow
the engine to cool.
3.
Release the cushion and remove the fuel tank;
refer to
Releasing the Cushion for Rear Access
(page
19).
4.
Inspect the belt
(Figure
if it is worn; refer to
(page
31).
Note:
The signs of a worn belt include
squealing while the belt is rotating, frayed edges,
burn marks, and cracks on the belt.
Figure 42
1. Extension spring
41).
41).
Adjusting the Track
13
to replace the other
EUTRAL
42). Replace the belt
Replacing the Drive Belt
2. Belt
Replacing the Drive Belt
Service Interval: Every 300 hours
1.
Park the machine on a level surface, move
the motion-control levers to the N
position, engage the parking brake, and lower
the hopper.
2.
Shut off the engine, and remove the key. Allow
the engine to cool.
3.
Release the cushion and remove the fuel tank;
refer to
4.
Raise the rear of the machine and support the
machine on jack stands.
5.
Remove the skid plate
-
LOCK
1. Rear bolt (2)
2. Skid plate
6.
Remove the extension spring
7.
Remove the 2 bolts and 2 nuts and loosen the
2 set screws on the coupler. Remove the gear
pump from the pump mount
Note:
from the pump.
g189546
31
Removing the Fuel Tank (page
(Figure
Figure 43
3. Side bolt (4)
(Figure
You do not need to remove the fittings
-
EUTRAL
LOCK
27).
43).
g325648
(Figure
42).
44).
Advertisement
Table of Contents
