Table of Contents
Advertisement
1. Dump switch—raise and
lower the hopper.
After Operation
After Operation Safety
General Safety
•
Engage the parking brake, shut off the engine,
remove the key, and wait for all movement to
stop before adjusting, cleaning, or repairing the
machine.
•
Do not touch parts that may be hot from operation.
Allow them to cool before attempting to maintain,
adjust, or service the machine.
•
Clean debris from drives, mufflers, and the engine
to help prevent fires. Clean up oil or fuel spills.
•
Use care when loading or unloading the machine
into a trailer or truck.
Removing Debris from the
Machine
1.
Park the machine on a level surface, move
the motion-control levers to the N
position, engage the parking brake, and lower
the hopper.
2.
Shut off the engine and remove the key. Allow
the engine to cool.
3.
Clean the inside of the hopper using a hose.
Figure 11
2. Swivel switch—turn the
hopper left and right.
EUTRAL
Important:
material from the inside of the hopper; this
may cause damage to the machine.
4.
Clean any debris from under the hopper.
5.
Wipe away debris from the air cleaner.
6.
Clean any debris buildup on the engine and in
the transmission with a brush or blower.
Important:
it out. If you use water, keep it away from
electrical parts and hydraulic valves. Do not
use a high-pressure washer. High-pressure
washing can damage the electrical system
and hydraulic valves or deplete grease.
Lowering the Hopper
g322672
without Power
1.
Install the cylinder lock; refer to
Cylinder Lock (page
2.
Ensure that the tub is empty.
3.
Place a large drain pan under the
hydraulic-manifold block
1. Hydraulic-manifold block
-
LOCK
4.
Disconnect the hose fittings in the manifold
block and allow the fluid to drain into the pan.
Note:
recycling center.
15
Do not use a hammer to remove
Blow out dirt rather than wash
20).
(Figure
Figure 12
Dispose of the used fluid at a certified
Using the
12).
g322673
Advertisement
Table of Contents
