Something Not Working - Electrolux ESL 67930 User Manual

Something not working

The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights,
which can be solved with the help of the indications described in the chart,
without calling out an engineer.
Open the door and carry out the following suggested corrective actions.
Fault code and malfunction
Water tap control light illuminated,
point-shaped optical signal is flashing,
appears in the digital display,
intermittent audible signal,
The dishwasher does not fill with water
point-shaped optical signal is flashing,
appears in the digital display,
intermittent audible signal,
The dishwasher will not drain
point-shaped optical signal is flashing,
appears in the digital display,
intermittent audible signal,
Anti-flood device is activated
Remember to switch off the appliance before carrying out any corrective action.
something not working electrolux 33
Possible cause and solution
The water tap is blocked or furred with
limescale.
Clean the water tap.
The water tap is turned off.
Turn the water tap on.
The filter (where present) in the threaded
hose fitting at the water inlet valve is
blocked.
Clean the filter in the threaded hose.
The water inlet hose has not been
correctly laid or it is bent or squashed.
Check the water drain hose connection.
The sink spigot is blocked.
Clean out the sink spigot.
The water drain hose has not been
correctly laid or it is bent or squashed.
Check the water drain hose connection.
Close the water tap and contact your
local Service Force Centre.