Something Not Working - Electrolux ESF 63020 User Manual

appliance door, disconnect the water inlet
pipe and empty it.
Moving the machine
If you have to move the machine (moving
house etc....):
1. Unplug it.
2. Turn the water tap off.

Something not working

The dishwasher will not start or stops during
operation.
Certain problems are due to the lack of sim-
ple maintenance or oversights, which can be
solved with the help of the indications de-
Fault code and malfunction
• continuous flashing of the start/cancel indica-
tor light
• 1 flash of the end of programme indicator light
The dishwasher does not fill with water
• continuous flashing of the start/cancel indica-
tor light
• 2 flashes of the end of programme indicator
light
The dishwasher will not drain
• continuous flashing of the start/cancel indica-
tor light
• 3 flashes of the end of programme indicator
light
• The programme does not start
Once these checks have been carried out,
switch on the appliance: the programme will
continue from the point at which it was inter-
rupted.
If the malfunction or fault code reappears
contact the Service Force Centre.
For other fault codes not described in the
above chart, please contact your local Serv-
3. Remove the water inlet and discharge
hoses.
4. Pull the machine out together with the
hoses.
Avoid over tilting the machine during trans-
portation.
scribed in the chart, without calling out an
engineer.
Switch off the dishwasher, open the door
and carry out the following suggested cor-
rective actions.
Possible cause and solution
• The water tap is blocked or furred with lime-
scale
Clean the water tap
• The water tap is turned off
Turn the water tap on
• The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked
Clean the filter in the threaded hose
• The water inlet hose has not been correctly laid
or it is bent or squashed
Check the water drain hose connection
• The sink spigot is blocked
Clean out the sink spigot
• The water drain hose has not been correctly laid
or it is bent or squashed
Check the water drain hose connection
• Anti-flood device is activated
Close the water tap and contact your local Service
Force Center.
• The dishwasher's door has not been properly
closed
Close the door
• The main plug is not plugged in
Insert the main plug
• The fuse has blown out in the household fuse
box
Replace the fuse
• Delay start has been set
If dishes are to be washed immediately, cancel the
delay start
ice Force Centre, quoting the model (Mod.),
product number (PNC) and serial number
(S.N.).
This information can be found on the rating
plate located on the side of the dishwasher
door.
electrolux 15