Batteries - PrimAster PMAB 20 Turbo Original Instructions Manual

WARNING
Do not try to charge non-rechargeable batteries with this charger.
To avoid danger, a damaged mains supply pipe must be replaced by the manuf-
acturer.
Read and understand the operating instructions before
using the appliance. Familiarise with the control elements
and how to use the appliance properly.
Abide by all the safety measures stated in the service
manual. Act responsibly toward third parties. The operator
is responsible for accidents or risks to third parties.
The appliance must be stored in a dry place and protected
from frost.
No metal parts may enter the shaft to slide the battery
(risk of short circuit). Never use the charger in moist or
wet conditions. Only use the device indoors. Make sure
the system voltage corresponds to the charger type plate
details. There is a risk of electric shock.
Cable connections to be separated by pulling the plug
only. Pulling the cable could damage both the cable
and plug. As a result, electric safety would no longer be
guaranteed.

BATTERIES

WARNING
Risk of fire! Risk of explosion!
Never use damaged, defective or deformed accumulators.
Never open or damage the accumulator or let it fall on the
ground.
Never charge the battery in an environment with acids
and easily flammable materials.
Protect the battery against heat and fire.
Battery to be used at the ambient temperatures between
10°C and +40°C only.
Never put the battery on heaters and do not expose it to
strong sunlight for a long time.
After being subject to heavy load, let the battery cool
down first.
Short circuit - do not bridge the accumulator contacts with
metal parts.
The accumulator must be packaged (plastic bag, box) or
accumulator contacts must be sealed up for accumulator
disposal, transport or storage.
Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type of
battery pack may create a risk of fire when used with
another battery pack.
Use power tools only with specifically designated battery
packs. Use of any other battery packs may create a risk of
injury and fire.
When battery pack is not in use, keep it away from other
metal objects, like paper clips, coins, keys, nails, screws
or other small metal objects, that can make a connection
Never use the charger when the cable, plug or the
machine is damaged by external influences.
Make sure the cooling function is not limited by covering the
cooling slots. Do not operate the appliance near heat sources
or on a flammable surface.
Never open the charger. Contact a specialised workshop in
case of any defect.
The outer battery surface must be clean and dry before the
battery starts being charged.
Chargers are exclusively suitable to charge these replace-
able batteries:
Typ LI 22-2 / LBB25R
Charging any other battery is not allowed.
from one terminal to another. Shorting the battery
terminals together may cause burns or a fire.
Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally occurs,
flush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause
irritation or burns.
Vapours may leak out in case of unauthorised use or
when using a damaged accumulator. Bring fresh air and
seek medical advice if experiencing difficulties. Vapours
may irritate the respiratory system.
Transporting Lithium Batteries
Lithium-ion batteries are subject to the Dangerous
Goods Legislation requirements. Transportation of
those batteries has to be done in accordance with local,
national and international provisions and regulations.
The user can transport the batteries by road without
further requirements.
Commercial transport of Lithium-Ion batteries by third
parties is subject to Dangerous Goods regulations.
Transport preparation and transport are exclusively to
be carried out by appropriately trained persons and
the process has to be accompanied by corresponding
experts.
When transporting batteries:: Ensure that battery contact
terminals are protected and insulated to prevent short
circuit. Ensure that battery pack is secured against
movement within packaging. Do not transport batteries
that are cracked or leak. Check with forwarding company
for further advice
GB ENGLISH
23