Table of Contents
Advertisement
AXIS Q16 Network Camera Series
Additional settings
Record video when the camera detects motion
This example explains how to set up the camera to start recording to the SD card five seconds before it detects motion and to
stop one minute after.
Make sure that AXIS Video Motion Detection is running:
1. Go to Settings > Apps > AXIS Video Motion Detection.
2. Start the application if it is not already running.
3. Make sure you have set up the application according to your needs.
Create a rule:
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under Application, select AXIS Video Motion Detection (VMD).
4. In the list of actions, under Recordings, select Record video while the rule is active.
5. Select an existing stream profile or create a new one.
6. Set the prebuffer time to 5 seconds.
7. Set the postbuffer time to 60 seconds.
8. In the list of storage options, select SD card.
9. Click Save.
Record video when the camera detects loud noises
This example explains how to set up the camera to start recording to the SD card five seconds before it detects loud noise and to
stop one minute after.
Note
The following instructions require that a microphone is connected to audio-in.
Turn on audio:
1. Set up the stream profile to include audio, see Add audio to your recording on page 16.
Turn on audio detection:
1. Go to Settings > System > Detectors > Audio detection.
2. Adjust the alarm level according to your needs.
Create a rule:
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under Audio, select Audio Detection.
4. In the list of actions, under Recordings, select Record video.
5. Select the stream profile where audio has been turned on.
6. Set the prebuffer time to 5 seconds.
14
Advertisement
Table of Contents
