Advertisement
Operation (continued)
CHILD LOCK
The child lock prevents unsupervised operation by children and this program only works in standby mode.
To set: In standby mode, touch and hold Lock Turntable/Off for 3 seconds, then a beep will sound and the
display will show LOCK ON. In the locked state, all pads are disabled.
To cancel: Touch and hold Lock Turntable/Off for 3 seconds, then a beep will sound and the display will show
LOCK OFF.
TURNTABLE
Turn off the turntable: During cooking, touch Lock Turntable/Off pad once to turn off the turntable. The display
will show TURNTABLE OFF.
Turn on the turntable: During cooking, if you have turned off the turntable, touch Lock Turntable/Off pad once
to turn on the turntable. The display will show TURNTABLE ON.
NOTE: When the cooking starts, the default turntable function is Turntable On. For sensor cook, sensor reheat, potato, popcorn, soften/melt,
time defrost and weight defrost, the turntable cannot be turned off. The Lock Turntable/Off pad is invalid.
PAD ADHESION PROTECTION
In any state, if any pad on the control panel is in adhesion for 60 seconds, the program stops working immediately,
the display shows FAIL and the system will sound a beep. If the pad is in adhesion all the time, a beep will sound
every one minute. All pads are invalid at this time. After troubleshooting, touch the Stop/Cancel pad to return to
standby mode.
Care and Cleaning
EXTERIOR
The outside surface is pre-coated steel and plastic. Clean the outside with mild soap and water; rinse and dry with
a soft cloth. Do not use any type of household or abrasive cleaner.
DOOR
Wipe the window on both sides with a damp cloth to remove any spills or spatters. Metal parts will be easier to
maintain if wiped frequently with a damp cloth. Avoid the use of spray and other harsh cleaners as they may stain,
streak or dull the door surface.
TOUCH CONTROL PANEL
Care should be taken in cleaning the touch control panel. If the control panel becomes soiled, open the oven door
before cleaning. Wipe the panel with a cloth dampened slightly with water only. Dry with a soft cloth. Do not scrub
or use any sort of chemical cleaners. Close door and touch STOP/CANCEL.
INTERIOR
Cleaning is easy because little heat is generated to the interior surfaces; therefore, there is no baking and setting of
spills or spattering. To clean the interior surfaces, wipe with a soft cloth and warm water. DO NOT USE ABRASIVE OR
HARSH CLEANERS OR SCOURING PADS. For heavier soil, use baking soda or a mild soap; rinse thoroughly with hot
water.
WAVEGUIDE COVER
The waveguide cover is located on the right side in the oven cavity. It is made from mica so requires special care.
Keep the waveguide cover clean to assure good oven performance. Carefully wipe with a damp cloth any food
spatters from the surface of the cover immediately after they occur. Built-up splashes may overheat and cause
16
Advertisement
